Audi 80/Avant (B4)

since 1991-1995 release

Repair and operation of the car



Audi 80/Avant
+ Technical specification
+ Engines
+ System of production of the fulfilled gases
+ Cooling system
+ Fuel tank and fuel pump
+ Air filter and airintaking channels
- System of injection
   + System of injection Mono-Motronic
   + System of injection Digifant
   + System of injection KE-III-Jetronic
   - Systems of injection of MPI and MPFI
      Operating procedure
      Lambda regulation
      Malfunctions and independent diagnostics
      Independent repair
      Visual check
      Check of separate elements
      Removal of elements
      Hummock drive of "gas"
      Check of the mode of idling and analysis of exhaust gases
      List of malfunctions
+ Coupling
+ Transmission and transmission
+ Suspension bracket and steering
+ Brake system
+ Anti-blocking system of brakes
+ Wheels and tires
+ Body electrical system
+ System of ignition
+ Lighting
+ Signaling devices
+ Devices and auxiliary devices
+ Heating and ventilation
+ Body elements
+ Search of malfunctions
+ Specifications





Removal of elements

Vpryskny nozzles (white shooters) can be removed only together with the fuel distributor. For this purpose it is necessary to weaken fixing bolts of the distributor of fuel (black shooters).

Removal of a flowmeter of air

Many components of system of injection do not require no additional instructions for dismantle. Exceptions are described in the following sections.

 PERFORMANCE ORDER

  1. To weaken an air flowmeter sleeve collar.
  2. To remove the air flowmeter plug.
  3. To remove the top part of the air filter together with an air flowmeter as it is described in the head "Air filter and inlet channels".

Removal of nozzles

 PERFORMANCE ORDER

  1. To remove an air inlet sleeve between the air filter (an air flowmeter) and the engine.
  2. To separate and put aside high-voltage wires of system of ignition.
  3. To separate plugs of nozzles.
  4. To turn off the fuel distributor from an inlet collector of the engine.
  5. To disconnect a vacuum hose from the fuel supply pressure regulator.
  6. It is careful to disconnect the fuel distributor with all six nozzles in the direction up from an inlet collector of the engine.
  7. For removal of one separate nozzle to remove a safety bracket from the fuel distributor and to separate a nozzle.
  8. Installation: before installation to replace sealing rings of round section on all nozzles.
  9. To oil all sealing rings new engine.
  10. It is very careful to insert each nozzle separately not to squeeze or to damage otherwise any of rings.







http://b3-b4.ru/