- You can pierce isolation of a cable by means of a control lamp with needle contact and establish what cables are energized.
- Choose the electrical circuitry corresponding to the required switch.
- At first it is necessary to check whether switches are powered; for this purpose it is necessary to include ignition or lighting several times.
- Then it is checked whether carries out the switch in the relevant provision tension further on a chain.
- On the example of the ignition lock switch check looks as follows:
- To remove a combination of devices that wires became available.
- To connect a wire of a control lamp to "weight".
- To pierce a control needle isolation of the checked wire.
- Both thick red wires of the plug 30 have to be constantly energized the accumulator.
- The gray-yellow plug of the R-chain is in ignition lock "rest position" energized, at turn of a key giving of food stops.
- The black-yellow wire of the plug X is energized only in the provision of a key "ignition is included"; as well as a thin red wire to a buzzer of parking light and radio.
- The black wire of the plug 15 is powered in provisions "ignition is included" and "start".
- The red-black wire of the plug 50 of the order of start of a starter of the engine is energized only in situation "start".
|
|