Audi 80/Avant (B4)

since 1991-1995 release

Repair and operation of the car



Audi 80/Avant
+ Technical specification
+ Engines
+ System of production of the fulfilled gases
+ Cooling system
+ Fuel tank and fuel pump
+ Air filter and airintaking channels
+ System of injection
+ Coupling
+ Transmission and transmission
+ Suspension bracket and steering
+ Brake system
+ Anti-blocking system of brakes
+ Wheels and tires
+ Body electrical system
+ System of ignition
- Lighting
   Lighting check
   Spare lamps
   Replacement of lamps
   Removal of headlights
   Check of adjustment of headlights
   Fog lights
   Independent installation of fog lights
   Indexes of turns
   Back lamps
   Illumination of registration plates
   Other lighting fixtures
   Dashboard illumination
+ Signaling devices
+ Devices and auxiliary devices
+ Heating and ventilation
+ Body elements
+ Search of malfunctions
+ Specifications





Back lamps

Replacement of lamps of back lamps


To remove a cartridge (1) after an otzhatiya of a rotary latch (shooter).


The boss of a headlight (2) is separated from the case of a headlight (1).


The switch of a headlight of a backing (shooter) is on the top party of the transmission. On this illustration we look in a gleam between the engine and a back wall of a motor compartment.


Lighting in a cover of a luggage compartment:

1 – an opening for installation in the lamp case;
2 – boss of a lamp;
3 – glow lamp.


 PERFORMANCE ORDER

  1. External back lamps: to turn a rotary latch on the left and to remove a cartridge.
  2. Lamps in a cover of a luggage compartment: at first to disconnect a cover.
  3. To turn a cartridge of a lamp approximately on 30 ° to the left (counterclockwise) and to extend.
  4. Replacement of lamps takes place in all cases equally – to slightly press a lamp in its cartridge, to turn to the left and to take out.
  5. At installation of a dvukhnitevy lamp for a stoplight and back marker lights pay attention that their side fixing pins are located at various height. Thanks to it the lamp can be put without effort only in one certain situation.

Removal

 PERFORMANCE ORDER

  1. External back lamps: to take out a cartridge of a lamp (see the previous section).
  2. To turn off a luggage carrier covering in the field of back fires.
  3. To turn out four six-sided nuts from a luggage compartment.
  4. To remove outside the case of lamps. If it stuck to a body because of the laid sealing cord, it is necessary to hook its screw-driver which is wrapped up in a rag.
  5. Separate lamps on a cover of a luggage compartment: to remove a cartridge(s) of lamps (see the previous section).
  6. To remove a castle element at the right back headlight, having weakened two six-sided bolts.
  7. To turn out in total four six-sided nuts from the inside of a cover.
  8. These back headlights can also stick to a body because of a sealing cord – to hook the screw-driver.
  9. At installation it is necessary to use a new sealing cord.
  10. Strip of lamps on a cover of a luggage compartment: to work as well as at removal of separate headlights, only, that it will be necessary to disconnect bigger quantity of bolts.







http://b3-b4.ru/