Audi 80/Avant (B4)
since 1991-1995 release
Repair and operation of the car
+ Technical specification
+ System of production of the fulfilled gases
+ Cooling system
+ Fuel tank and fuel pump
+ Air filter and airintaking channels
+ System of injection
+ Transmission and transmission
+ Suspension bracket and steering
+ Brake system
+ Anti-blocking system of brakes
+ Wheels and tires
- Body electrical system
Minus to "weight"
Orientation in the electrical system
Additional block of the relay
Relay and control units
Unloading relay of contact of X
Table of safety locks
+ Full electrical circuitry of the Audi 80 car: 2-liter 4-cylinder engine (66 kW)
+ 2-liter 4-cylinder engine (85 kW)
+ 2,3-liter 5-cylinder engine (98 kW)
+ 2,6-liter 6-cylinder engine (110 kW)
+ Additional equipment
- Rechargeable battery
On how many there are enough reserves?
Control of level of electrolyte
Accumulator charging check
Start of the engine with the discharged accumulator
Check of a condition of a maple or polilinovy belt
Tension of a maple belt
Tension of a maple or poliklinovy belt
The belt torn maple
Engine overheat because of damage of a maple belt
Review of maple and poliklinovy belts
Replacement of a maple belt
List of malfunctions
List of malfunctions
+ System of ignition
+ Signaling devices
+ Devices and auxiliary devices
+ Heating and ventilation
+ Body elements
+ Search of malfunctions
The rechargeable battery is the center of the onboard Audi 80 electrical system. Various consumers of food use a stock of its energy, and the rechargeable battery from the generator is charged.
Principle of work
The electrode (lead plate) contacts to the divorced sulfuric acid (electrolyte) and gives under the influence of solution positive ions, that is the chastets electrically loaded, to electrolyte. Thereby between electrolyte and a lead plate voltage is created.
However tension created as a result "voluntary" transition of charged particles is, not enough, and on the accumulator give charge voltage. As a result of it sulfate of lead of the discharged rechargeable battery turns on a positive electrode into lead dioxide, and on negative – into spongy lead. At the same time in electrolyte sulfuric acid, an external sign of almost complete process of charging – emergence of vials of gas is again formed.
At a discharge of the accumulator there is the return process. Dioxide of lead of a positive plate and spongy lead negative turn into lead sulfate again, and sulfuric acid is spent, and water is formed. Therefore with a discharge of the rechargeable battery acid density decreases.
Designation of the rechargeable battery
In the Audi 80 models with 4-and 5-cylinder engines the rechargeable battery is located behind on the right in a motor compartment. In models with the 6-cylinder engine: the accumulator is located at the left ahead in a motor compartment. On installation sites it is protected by a cover.
Parameters of the rechargeable battery
Tension and capacity: the first (12 V), of course, specifies tension in designation 12 B/40 Ach. Behind inclined line the current which the accumulator is capable to give for a unit of time is specified – Ach means ampere-hours. It is the nominal capacity of the battery measured according to standard conditions. In practice it is necessary to count only on 2/3 specified ampere-hours; at older accumulator only on a half.