Audi 80/Avant (B4)

since 1991-1995 release

Repair and operation of the car



Audi 80/Avant
+ Technical specification
+ Engines
+ System of production of the fulfilled gases
+ Cooling system
+ Fuel tank and fuel pump
+ Air filter and airintaking channels
+ System of injection
+ Coupling
+ Transmission and transmission
- Suspension bracket and steering
   Control of a condition of a casing of the steering mechanism
   Check of dustproof covers and side play of tips of cross steering drafts
   Check of dustproof covers of hinges of a forward suspension bracket
   Check of a side play of steering
   Check of a maple or poliklinovy belt
   Check of level of working liquid
   Check of a side play of the wheel bearing
   Shock-absorbers
   List of malfunctions
   Adjustment of angles of installation of wheels
   Measurement of adjustment of angles of installation of wheels
   List of malfunctions
   Repair of a running gear and steering
   Repair of a forward suspension bracket
   Repair of a back suspension bracket
   Steering
   Steering repair
   List of malfunctions
   Adjustment of the steering mechanism
   Filling with liquid and pumping of a hydraulic system of the power steering
   Safety cushion
   Requirements of safety measures
+ Brake system
+ Anti-blocking system of brakes
+ Wheels and tires
+ Body electrical system
+ System of ignition
+ Lighting
+ Signaling devices
+ Devices and auxiliary devices
+ Heating and ventilation
+ Body elements
+ Search of malfunctions
+ Specifications





Steering repair

Check on tightness of the steering mechanism with the amplifier

If in a receiver the lowered liquid level is found, then it is necessary to check all system of the steering mechanism as soon as possible. Otherwise the amplifier of the steering mechanism can suddenly stop work during the movement. The sequence of check is given below:

 PERFORMANCE ORDER

  1. To turn out a steering wheel once to the right and once on the left against the stop. Thus in the power steering the highest possible pressure is formed, and untight places will become more noticeable.
  2. To leave a steering wheel in one of extreme provisions and to check the following places for leakage:
  3. Rotor valve. It is located approximately where the steering column connects to the steering mechanism. Working liquid in this case acts in interior of the car under the control panel on a forward wall.
  4. Dribble on sealing laying of a gear lath or sealing laying in the left tip. For check to weaken clips of a casing and to shift it aside.
  5. On the hydraulic pump. For detection of leakage, perhaps, before check it is necessary to wash the engine.
  6. On connections of pipelines. It is necessary to check and if necessary to dozatyanut all connections separately.

Maple and poliklinovy belts

In more detail you learn about a maple or poliklinovy belt of the hydraulic pump in the section Generator.








http://b3-b4.ru/